WaveWare Apollo T-2000 Technické informace stáhnout pdf (Strana 40)

Certification Manual

- 40 -

The Automation Module has a terminal strip along the bottom of the

circuit card by which it is connected to the bus line. Terminal 1 is positive,

terminal 2 is Bus A, terminal 3 is Bus B, and terminal 4 is negative. Along

the edge of the card is a male serial port. In order to connect this to the

server computer, a male/female straight through serial cable is required.

There is no programming that needs to be performed on this module out of

the box.

Transceiver

The Superbus Transceiver performs the vital

function of extending the wireless range of the Control

Panel. Remember, the Concord 4 has a specified

open-air range of 1000’. The Concord Ultra has a

specified open-air range of 2000’. The Superbus

Transceiver increases that by another 2000’ open-air.

This can be increased by roughly 500’ if the

transceiver is mounted inside a metal enclosure.

The Superbus Transceiver has a terminal strip located on the bottom

of the board by which it is connected to the bus line. Terminal 1 is positive,

terminal 2 is Bus A, terminal 3 is Bus B, and terminal 4 is negative. At the

top of the card in each corner, there are two, two-slot terminals. These

terminals are used to connect the antennae and ground the transceiver

board to the box, if a metal enclosure is being used. The inside terminals

are for the antenna and the outside terminals are for the grounding

screws/wires.

There is no programming that needs to be performed on this module out of

the box.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 113 114

Žádné komentáře

WaveWare Apollo T-2000 Technické informace Strana 40