WaveWare Apollo T-2000 Technické informace stáhnout pdf (Strana 84)

Certification Manual

- 84 -

WaveWare Wall Pagers

The WaveWare

Wall Pager is a wall

mounted POCSAG

paging receiver with LED

display. The Wall Pager is

capable of holding up to 6

Capcodes, and 24 active

messages. Most facilities mount the device at the end of a hall or over a

nurse’s station. The Wall pager is available in 51” and 28” sizes.

Installation

The WaveWare Wall Pager is mounted to the wall with two brackets

that bolt to the end-caps of the pager. The only thing the pager requires is a

conventional 110VAC outlet for power.

Programming

The Wall Pager can be connected to a PC via serial cable, and there

is programming software available from the manufacturer for programming.

However, most of the features of the Wall Pager are programmed “Over

The Air” with commands that can be paged via the WaveWare

programming software. For complete instructions and screen shots, please

refer to the manufacturer’s manual, otherwise the following procedure and

table list the typical programming features that Alliance specifies.

Programming via serial connection

Step 1 – Install the software provided on the included CD for “On-

Site” Paging (POCSAG Receivers) or for “Wide Area” (Flex

Receivers).

Step 2 – Attach the sign to the Com Port on the right side of the sign.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 113 114

Žádné komentáře

WaveWare Apollo T-2000 Technické informace Strana 84